Using The Mounting Bracket - Icom IC-V8000 Instruction Manual

2
INSTALLATION
I Location
1
2
Select a location which can support the weight of the trans-
3
ceiver and does not interfere with driving in any way. We rec-
4
ommend the locations shown in the diagram below.
5
NEVER place the transceiver where normal operation of the
6
vehicle may be hindered or where it could cause bodily injury.
7
NEVER place the transceiver where air bag deployment may
8
be obstructed.
9
DO NOT place the transceiver where hot or cold air blows di-
10
rectly onto it.
11
AVOID placing the transceiver in direct sunlight.
12
13
• Example— Installation location
14
15
16
17
18
19
20
21
9
I Using the mounting bracket
➀
Drill 4 holes where the mounting bracket is to be installed.
") when using nuts; approx. 2–3 mm (
• Approx. 5.5–6 mm ( 3 ⁄
16
when using self-tapping screws.
➁
Insert the supplied screws, nuts and washers through the
mounting bracket and tighten.
➂
Adjust the angle for the clearest view of the function dis-
play.
Nut
Spring washer
Flat washer
When using
self-tapping
screws
Spring
washer
")
1 ⁄
16
Mounting
bracket
Mounting
nut