Icom IC-V8000 Instruction Manual page 27

I General description
The transceiver has 207 memory channels including 6 scan
edge memory channels (3 pairs), and 1 call channel. Each of
these channels can be individually programmed with operat-
ing frequency (p. 00), duplex direction (p. 00), subaudible
tone encoder or tone squelch and its tone frequency (pgs. 00,
00) and skip information.* (p. 00)
In addition, a total of 10 memory banks, A to J, are available
for making groups with usage, etc.
*except for scan edge memory channels.
I Memory channel selection
D Using the tuning dial
Push [M/CALL(PRIO)] to select
memory mode.
Appears
q Push
[M/CALL(PRIO)]
once or twice to select
memory mode.
• "M" indicator appears
w Rotate the tuning dial to
select the desired mem-
ory channel.
• Programmed memory
channel can only be se-
lected.
MEMORY OPERATION
D Using the [Y]/[Z] keys
z Push [MR/CALL] to select memory mode.
MR/CALL
x Push [Y] or [Z] to select and set the desired
memory channel.
• Pushing [Y] or [Z] for more than 0.5 sec. acti-
Y/Z
vates a scan.
• If scan is activated, push [Y] or [Z] again to stop it.
D Using the keypad
z Push [MR/CALL] to select memory mode.
MR/CALL
x Push [
ENT
meral input.
c Push 3 appropriate digit keys to input a chan-
Y/Z
nel number.
• When inputting non-programmed channel num-
bers, the previous memory channel appears.
• Push only 1 appropriate digit key, [
or [ 3], then push [
PRIO
lect scan edge channels. "✱" and "#" can be used
for A and b respectively.
6
C] to activate the keypad for nu-
1], [
MONI SCAN
✱] or [
#] to se-
Z Z
VOL SQL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
2]
16
17
18
19
20
21
24