I Memory Clearing - Icom IC-V8000 Instruction Manual

6
MEMORY OPERATION

I Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
q Push [V/MHz(SCAN)] to select VFO mode.
w Push [MW(S.MW)] momentarily.
• "M" indicator and the memory channel number blink.
e Rotate the tuning dial to select the memory channel to be
cleared.
• Memory channels not yet programmed are blank.
[EXAMPLE]: Clearing memory channel 20.
V/MHz
Push to select VFO.
SCAN
Push MW
S.MW
29
MW
Push momentarily.
S.MW
briefly, then push MW again for 1 sec.
S.MW
r Push [MW(S.MW)] briefly, then push [MW(S.MW)] again
for 1 sec.
• 3 beeps sound, then the frequency is cleared.
• "M" indicator blinks continuously.
• Scan edges, 1A/1b, 2A/2b, 3A/3b, and the call channel cannot
be cleared.
This operation must be performed within 1.5 sec.
t Push any switch, except [MW(S.MW)], to return to VFO
mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
Rotate
"
"
Push any switch.
Beep
"
Beep
"
Beep
"
for selecting memory channel.