I Programming A Memory Channel - Icom IC-V8000 Instruction Manual

6
MEMORY OPERATION

I Programming a memory channel

VFO settings, including the set mode contents such as sub-
audible tone frequency, etc., can programmed into a memory
channel.
q Set the desired frequency in VFO mode.
➥ Push [V/MHz(SCAN)] to select VFO mode.
➥ Set the frequency using the tuning dial.
➥ Set other data (e.g. tone frequency, duplex information,
etc.) if required.
w Push [MW(S.MW)] momentarily.
• "M" indicator and the memory channel number blink.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the front panel.
V/MHz
Push
SCAN
Rotate
25
Rotate for setting frequency, etc.
Push MW for 1 sec. and continue to pushing
S.MW
e Rotate the tuning dial to select the memory channel to be
programmed.
• Memory channels not yet programmed are blank.
r Push [MW(S.MW)] for 1 sec. to program.
• 3 beeps sound
• Memory channel number automatically advances when contin-
uing to push [MW(S.MW)] after programming.
✔CONVENIENT
Memory programming can be performed in versatile ways
e.g. memory channel to the same (or different) memory chan-
nel, memory channel to the call channel, etc.
MW
Push momentarily.
S.MW
➠
"
"
Beep
"
Beep
"
Beep
"