Icom IC-V8000 Instruction Manual page 41

I Scan start/stop
D Preparation
Scan resume condition (p. 00); program the scan edges
(p. 00); program 2 or more memory channels (p. 00); set skip
settings, if desired (p. 00)
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz(SCAN)]; or memory mode for memory scan with
[M/CALL(PRIO)].
w Set the squelch to the point where noise is just muted.
e Push [V/MHz(SCAN)] for 1 sec. to start the scan.
• To change the scanning direction, rotate the tuning dial.
• The memory channel readout blinks the scan type as follows:
During full scan
Push [SET(LOCK)] to select full
or programmed scan in
sequence.
During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P3 are available when
they are programmed.
During memory scan
r Push [SET(LOCK)] to switch full and programmed scan.
t To stop the scan, push [V/MHz(SCAN)].
z Push [VFO/LOCK] to select VFO mode for
SCAN
full/programmed scan; push [MR/CALL] to select
2
memory mode for memory scan.
x Set the squelch to the point where noise is just
SET
muted.
B
c Push [
2(T-SCAN)] to start the scan.
SCAN
• Push [Y] or [Z] for 1 sec. also starts the scan.
v Push [
B(D-OFF)] to switch full and pro-
SET
grammed scan.
b To stop the scan push [
[ A(MW)].
CLR
SCAN OPERATION
2(T-SCAN)] or
SCAN
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
38