Icom IC-V8000 Instruction Manual page 34

6
MEMORY OPERATION
Channel names can also be programmed via the mi-
crophone.
z Select the memory/call channel to be assigned memory
names.
➥ Push [MR/CALL] to select memory mode, then select
the desired memory channel via [Y]/[Z] or keypad.
• Scan edge channels can also be selected.
➥ Push [MR/CALL] for 1 sec. to select the call channel.
x Push [FUNC], then [
c Push [
B(D-OFF)].
SET
• Frequency readouts disappear.
v Push [Y]/[Z] to selected the desired character.
• The selected character blinks.
[EXAMPLE]: Programming "CLUB" into memory channel 1.
Select memory channel 1,
push , then push
31
1(ANM)] momentarily.
MONI
Push to select the character.
.
b Push [
B(D-OFF)] or [
SET
sor to left or right, respectively.
n Repeat steps b and n until the desired channel names
are displayed.
m Push [
B(D-OFF)] or [
SET
sor to left or right, respectively.
, Push [
A(MW)] to program the name and exit channel
CLR
names programmable condition.
. Push [FUNC], then push [
quency indication if desired.
Push or to move
the cursor.
Repeat
previous
C(T-OFF)] to move the cur-
ENT
C(T-OFF)] to move the cur-
ENT
1(ANM)] to return to fre-
MONI
Push .
steps.