Print And Wind Without A Tension Bar - Oce Colorado 1640 Operation Manual

Print and wind without a tension bar

Introduction
Winding media without a tension bar, loose winding, is used for most media that can be
transported well and is not too weak.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding without a tension bar you must select [no tension bar] under [Winding tension]. For
more information, see
• Make sure you have loaded a take-up roll on the roll winder. For more information, see
take-up roll core onto the roll winder on page
• The printer is ready to print.
IMPORTANT
Use the stop switch, to stop the winder immediately. Do not forget to switch it on again.
Procedure
1. On the operator panel tap on the [Output] icon.
2. Make sure [Wind the output] is set to [Yes].
NOTE
Make sure you set the output configuration in time, as you cannot change the
configuration once the media has passed the clamp.
Change the media settings on page
Print and wind without a tension bar
55.
76.
Chapter 3 - Handle the media
Load a
79