Print And Wind With A Locked Tension Bar - Oce Colorado 1640 Operation Manual

Print and wind with a locked tension bar

Print and wind with a locked tension bar
Introduction
Winding media with a locked tension bar is only used for stiff media, in order to prevent media
transportation issues.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding with a locked tension bar, you must select [locked tension bar] under [Winding
tension]. For more information, see
• Make sure you have placed a take-up roll core on the roll winder. For more information, see
Load a take-up roll core onto the roll winder on page
• Make sure you have tape ready.
• The printer is ready to print.
IMPORTANT
Use the emergency stop button, to stop the winder immediately. Do not forget to switch it on
again.
Procedure
1. On the operator panel tap on the [Output] icon.
2. Make sure [Wind the output] is set to [Yes].
NOTE
Make sure you set the output configuration in time, as you cannot change the
configuration once the media has passed the clamp.
86 Chapter 3 - Handle the media
Change the media settings on page
76.
55.