Print and wind without a tension bar
Print and wind without a tension bar
Introduction
Winding media without a tension bar, loose winding, is used for most media that can be
transported well and is not too weak.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding without a tension bar you must select [no tension bar] under [Winding tension]. For
more information, see
• Make sure you have loaded a take-up roll on the roll winder. For more information, see
take-up roll core onto the roll winder on page
• The printer is ready to print.
IMPORTANT
Use the stop switch, to stop the winder immediately. Do not forget to switch it on again.
Procedure
1. On the operator panel tap on the [Output] icon.
64
Chapter 3 - Handle the media
Change the media settings on page
44.
61.
Load a