General Workflow For Printing A Job - Oce Colorado 1640 Operation Manual

General workflow for printing a job

General workflow for printing a job
Introduction
There is a general workflow for using the Océ Colorado 1640 explained in this manual.
RIP
1. RIP
Prepare and submit a job in one of the supported RIP software applications. You can install
media profiles and also add or change media profiles and types here. For more information,
Configure media in the RIP on page 25
see
documentation.
2. Operator panel
Check your job and other jobs in the queue here. Pause, resume and remove a job, or cut the
media after a certain job.
You can also perform special actions via the operator panel, such as starting maintenance
actions or configuring the printer's system and connectivity settings.
3. Printing
Once your job has been submitted and passed the queue the printer prints your job in sheets
or roll-to-roll.
4. Mobile app
You can monitor the printer via the Remote Control app on your mobile device. The app gives
you alerts when operator action is required on media, maintenance or when other actions are
coming up.
104 Chapter 4 - Print a job
Operator Panel Printing Mobile app
or check the website of your RIP supplier for