Banding At Swath Boundary - Oce Colorado 1640 Operation Manual

Banding at swath boundary

Banding at swath boundary
Introduction
Solve banding at swath boundary on your print. Banding that shows at swath boundary as light
lines, dark lines, or gloss differences. Follow the procedure below. You can stop at any time in the
procedure when the problem is solved.
[1] Banding at swath boundary
Procedure
1. Perform media calibration.
2. Make sure that the [Automatic advance correction] setting in the RIP is enabled.
media settings on page
3. Change the [Advance correction] setting in the RIP. Decrease, smaller step, to minimize light
lines. Increase, bigger step, to minimize dark lines.
4. When you are printing in [High quality] print mode, tune the [Print strategy] setting.
media settings on page
5. Depending on the media type, it can help to lower the [Printer platen temperature] in the RIP.
Change the media settings on page
6. Select a higher quality print mode.
220 Chapter 8 - Troubleshooting and support
Calibrate the media on page
55.
55.
55.
Select a print mode on page
74.
Change the media settings on page
61.
Change the
55.
Change the