Oce Colorado 1640 Operation Manual page 243

6. Dampen the cloth with the cleaning liquid to remove any remaining ink.
IMPORTANT
• Use the prescribed cleaning liquid. Do not use any other cleaners.
• Do not wet the platen directly, as you can damage the printheads.
7. Open the suction holes with a 1mm diameter pin.
8. When all residue ink is removed, wait for 3 to 4 minutes to let the liquid evaporate.
9. Take a new and clean cloth to wipe the complete platen.
10. Dispose the gloves, cloths and pin as chemical waste according to local regulations.
11. Close the top cover.
After you finish
Reload the media. For more information, see
Load a media roll (position 1) on page 62
Chapter 8 - Troubleshooting and support
Clean the platen
.
243