Oce Colorado 1640 Operation Manual page 150

Replace the lubricators
18. Locate the lubricators on the right side of the curing carriage.
19. Repeat steps 10 to 17.
20. When the lubricators on both sides have been replaced, remove the paper.
21. Dispose the gloves as chemical waste according to local regulations.
22. Close the top cover.
23. On the operator panel tap [Replaced] to confirm you replaced the lubricators and end the action.
NOTE
When you have replaced the lubricators, some oil can drip on the platen and the platen
edge. When oil has spilled: open the top cover when the printer is not printing, put on
gloves, clean the oil with a lint free cloth and close the top cover again.
150 Chapter 5 - Maintain the system