Replace The Maintenance Tray - Oce Colorado 1640 Operation Manual

Replace the maintenance tray

Introduction
Replace the maintenance tray when the system gives a warning.
• The operator panel gives an orange warning when you can replace the maintenance tray.
• The operator panel gives a red warning when you must replace the maintenance tray. The
printing process is stopped until you have replaced the maintenance tray.
Before you begin
Use Océ Colorado 1640 prescribed:
• Nitrile gloves for handling ink
• Lint free cloths
• Maintenance tray
NOTE
For information on the prescribed maintenance materials, see
maintenance materials on page
CAUTION
Wear the Océ Colorado 1640 prescribed nitrile gloves. You can only wear the gloves for ten
minutes. After ten minutes you must put on new gloves to prevent contact with the ink.
IMPORTANT
Only open the maintenance drawer when the operator panel displays a message allowing you to
open it.
Procedure
1. On the operator panel tap on the [Tools] icon on the right.
2. Go to [Maintenance tray].
3. Tap on [Replace] and read the instructions.
4. Put on the Océ Colorado 1640 approved nitrile gloves.
160.
Replace the maintenance tray
List of Océ Colorado 1640
Chapter 5 - Maintain the system 129