Table of Contents
Advertisement
90
en | Configuring equipment using Utility tool
4.
5.
6.
Notice!
Note that the Version column of the Connected Receivers grid view may still show the same
firmware version for the SE receiver. The latest version number is not automatically refreshed
in the grid after the firmware upload. Click the [Scan] button under the Receivers column of
the SE Coordinators grid view to refresh the list.
7.
8.2.3
Adding available SE receiver to the SE coordinator
Follow the instructions below to add an SE receiver to an SE coordinator.
2018.03 | SE3v1.0 | DOC
A confirmation dialog box appears. Click the [Yes] button to proceed with the upload, or
the [No] button to abort.
Upon clicking the [Yes] button, the firmware will be uploaded to all connected and
available SE receivers. An indicator bar appears on screen to display the progress for the
firmware upload. The red and green LED of the SE coordinator will be turned on, while
the red and green LED of all the SE receivers will blink continuously for the entire
duration of upload. To abort the upload, click the [Cancel] button.
Upon successful firmware upload, the indicator bar shows the completed status. The red
and green LED of the SE coordinator and SE receivers will turn off once upload is
completed.
For each unsuccessful firmware upload, an error message window appears.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
