Table of Contents
Advertisement
Security Escort
Element
Password
System serial ports group
Password verify
Disabled
History filter output
Serial Output control
Remote system control If selected, this system is controlled by another system through a
Local Service Pages
Local Security Pages
All Local Pages
Wheelock port
Others
Serial Output restore
Modem init
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
Usage/Description
This is the password that is used to gain remote access to the
Security Escort System. If the first 5 characters of the password
match the remote systems password, read only access will be
allowed. If the first 8 characters match, you will be allowed to edit
databases remotely (not currently implemented). If all 12
characters match, you will also be allowed to change system
parameters remotely.
For verification, reenter the same password as above.
If selected, this system serial port is disabled (default).
If selected, this system serial port sends out whatever items that
are selected in the History Filter dialog.
If selected, this system serial port sends out the strings
programmed in the Serial Output field of the Transponder
Database Edit dialog's Area data. Also see Serial Output restore
field below.
proprietary protocol. This setting can only be used when two
systems are specifically designed to work together.
If selected, system will send service pages via the local port.
If selected, system will send security pages via the local port.
If selected, system will send both service and security pages via
the local port.
If selected, system will send both service and security pages via
the local port.
This string is transmitted on any system serial port programmed for
Serial Output control when the alarm is cleared. This string is
transmitted to the serial output to reset it to default. Up to 60
characters can be entered. Control characters can be entered as
[^][A] for control A.
This is the initialization string transmitted to the modem to set it
up for all communications except paging. Normally, this setting
does not need to change. To allow changes to this string, hold
down the <Shift> + <Ctrl> keys when this dialog is first opened.
This string is specific to each modem model. The default string
should work with most modems.
Technical Reference Manual
61
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
