Table of Contents
Advertisement
82
en | Configuring equipment using Utility tool
8
Configuring equipment using Utility tool
Use the Utility tool to modify network information of the SE coordinators, scan and enroll SE
receivers/SE transmitters to the SE coordinators, and upload firmware for SE coordinators, SE
receivers and SE transmitters.
The operation of the Utility tool is recommended for configurators or administrators only as
this involves the setup of the system hardware. The user must log in at "Reset Low Battery"
Authority Level in order to access the Utility tool.
The operations can be divided into three main sections, namely operations relating to SE
coordinator, SE receivers and SE transmitters.
Operations relating to SE coordinator include changing the network name, modifying the IP
address/Subnet Mask/Gateway/Port, and uploading SE coordinator firmware.
Operations relating to SE receivers include scanning SE receivers that is connected (enrolled)
to an SE coordinator, adding or removing SE receivers from an SE coordinator, uploading SE
receiver firmware, and so on.
The Utility tool also allows scanning of the SE transmitters, and uploading of SE transmitter
firmware.
8.1
Operations for the SE coordinator
8.1.1
Scanning SE coordinators
Opening the Utility Tool window will automatically scan all the SE coordinators of the Security
Escort system. The SE coordinators that are connected to the Security Escort system are
listed in the SE Coordinators grid view, together with their network details. To refresh the list
of SE coordinators, click the [Scan Coordinators] button.
Figure 8.1: Utility tool dialog
Details of the coordinators are described as below:
Element
Radio ID
2018.03 | SE3v1.0 | DOC
Usage/Description
The radio ID of the SE coordinator. This radio ID is the same number
as that is found on the back plate of the SE coordinator board. This
information cannot be changed by the user.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
