Table of Contents
Advertisement
104 en | Troubleshooting coordinators, points and receivers
Element
Disable idle processing Normally, this software registers with Windows to return to the
Enable algorithm
tweaks
ID Receiver / Point
Control room / Point
Map scale %
2018.03 | SE3v1.0 | DOC
Usage/Description
Security Escort system if there is any idle time. The Security Escort
system can use it to speed up its response to serial
communications and other background tasks. If selected, the
software will not register for the idle time. Normally, this checkbox
is not selected.
Windows can show the amount of time each application (task) is
taking. When this checkbox is not selected, it may appear that
Security Escort system is "hogging" the processor resources. This
is not true, because the Security Escort system is only taking the
time that Windows gives it through the idle process.
To prove this, select this checkbox. The amount of time that the
Security Escort System needs will drop dramatically, and it will
continue to operate normally (same communications responses
will be slowed by several hundred milliseconds).
Selecting this checkbox causes the Map scale, Alarm spot size,
and Linear/Low/Medium/Strong depth settings to be visible on
this dialog. It also controls the display of the SA% and Algorithm
settings in the Edit Transponder's Database Record dialog.
Assign an SE receiver for automated transmitter exchanges. The
Security Escort system contains a feature where the transmitter
identification number can be automatically entered into the
Subscriber database. This is used for entering transmitters when
issuing them to subscribers for the first time, and for transmitter
exchanges.
This automatic capture of the transmitter identification number is
accomplished by performing certain procedural steps (see the
Security Escort Operation Manual) and then using the transmitter to
make a test transmission in close proximity to a designated SE
receiver, usually located close to the Central Console.
By capturing the transmitter identification number in this manner,
keystroke errors are avoided during database entries and changes.
The SE receiver chosen for this purpose is designated as the ID
Capture Receiver. To assign the ID Capture Receiver, its SE
coordinator name and its Point Number are selected using the ID
Receiver and Point elements.
The Security Escort system software can activate an output to
attract attention, when there is an alarm that has been received,
and no operator has responded to the system yet. To assign the
output, select the SE coordinator that it is connected to, and the
Point Number.
This value changes the scale that the maps are presented with. It is
not intended for normal operation, but typically used for testing to
allow more of the map to be seen. The setting may range from 30%
to 400%. The Enable algorithm tweaks checkbox must be selected
for this to be visible.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
