Table of Contents
Advertisement
88
en | Configuring equipment using Utility tool
Figure 8.2: Scanning receivers
Details of the Connected Receivers are described as below:
Element
Radio ID
Address
Version
Details of the Available Receivers are described as below:
Element
Radio ID
Address
Version
8.2.2
Uploading SE receiver firmware
Follow the instructions below to upload the firmware of all Connected and Available
Receivers.
2018.03 | SE3v1.0 | DOC
Usage/Description
The radio ID of the SE receiver. This radio ID is the same number as
that is found on the back plate of the SE receiver board. This
information cannot be changed by the user.
Loop address of the SE receiver. The address is set via the dip switch
on the SE receiver. This information cannot be changed by the user.
Note: address 0 refers to the SE receiver that is built-in to the SE
coordinator.
Firmware version of the SE receiver.
Usage/Description
The radio ID of the SE receiver. This radio ID is the same number as that
is found on the back plate of the SE receiver board. This information
cannot be changed by the user.
Loop address of the SE receiver. The address is set via the dip switch on
the SE receiver. This information cannot be changed by the user. Note:
address 0 refers to the SE receiver that is built-in to the SE coordinator.
Firmware version of the SE receiver. The version will appear as 0.0.0.0
for the Available Receivers.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
