GE Medical Systems Solar 9500 Service Manual page 195

Field Replaceable Units, Parts Lists and Drawings: Disassembly/Assembly
First Time Power Up
Export To The Network...
Revision A
The first time you power-up a new hard drive from GE, the software self
configures and the items listed in the Solar 9500 System Configuration
Record are restored except for Alarm Graph Setup and Network Printer
Configuration. See "Print System Settings"
127(
Alarm Graph Setup and Network Printer Setup must be entered
manually.
Go to SERVICE MODE and select Display setup... then, select Save.
If multiple Solar 9500s are connected to the Unity Network MC network,
then the following items can be pushed across the network using the
network services export function as described on the next page.
Otherwise they have to be manually reentered.
Bed Layouts
Waveform Layouts
Parameter defaults
Alarm Graph Setup
Software
Exporting software or configuration information is a two step process:
First, the software or configuration information is pushed from one
Solar 9500 (the source) to one or more Solar 9500s (the destination).
Second, the software or configuration information is activated at the
local bed. This step must occur at each bedside individually while not
actively monitoring a patient.
1. Enter the Service Mode menu as instructed in
Menu" on page 4-2.
2. Under Network Services select Export To The Network... to send bed
layouts, unit defaults or Solar 9500 software to the Solar 9500 with
the new hard drive on the network. A window similar to the following
displays with selections for Units and Beds.
Solar 9500 Information Monitor
2001085-061
on page 4-31.
"Monitor Service
9-13