Cleaning; Cleaning Precautions; Exterior Cleaning; Cleaning The Touch Screen Display - GE Medical Systems Solar 9500 Service Manual

Cleaning

Cleaning Precautions

Exterior Cleaning

Cleaning the Touch Screen Display

6-4
Maintenance: Cleaning
Use one of the following approved solutions:
Cidex solution, or
Sodium hypochlorite bleach (diluted), or
Mild soap (diluted)
Lint-free cloth
Dust Remover (compressed air)
To avoid damage to the equipment surfaces, never use the following
cleaning agents:
organic solvents,
ammonia based solutions,
acetone solution,
alcohol based cleaning agents,
Betadine solution,
a wax containing a cleaning substance, or
abrasive cleaning agents.
To clean the exterior of the Solar 9500, follow this procedure:
1. Power down the Solar 9500 (according to the procedure outlined in
chapter 3, Installation) and disconnect the display from the power
source and the network.
2. Use a clean, lint-free cloth and one of the cleaning solutions listed
above. Wring the excess solution from the cloth. Do not drip any
liquid into open vents, switches, plugs, or connectors.
3. Dry the surfaces with a clean cloth or paper towel.
To clean the Touch Screen Display, follow this procedure:
1. Turn OFF at the mains power switch on the display and disconnect it
from the power source.
2. Clean the screen with an ammonia free glass cleaner and lint free
cloth.
&$87,21
Do not spray any glass cleaning solution or any general
cleaning solutions directly onto the monitor's display
surface. Always dampen the towel and then clean the
screen.
Solar 9500 Information Monitor
2001085-061
Revision A