Tram-Net Communication Check - GE Medical Systems Solar 9500 Service Manual

Pins for Pins for
D-Type Round
Connector Connector
Pin 1 Pin 8
Pin 2 Pin 2
Pin3 Pin 6
Pin 4 –
Pin 5 Pin 4
Pin 6 Pin 9
Pin 7 Pin 11
Pin 8 Pin 8
Pin 9 Pin 1
Pin 10 Pin 3
Pin 11 Pin 7
Pin 12 –
Pin 13 Pin 5
Pin 14 Pin 10
Pin 15 –

Tram-net Communication Check

6-20
Maintenance: Checkout Procedure
Analog Output Signals
Signal Source
Signal GND for Tram Waveforms
1
Trace I (ECG II )
Tram BP3 or SPO Value
2
Reserved for Future Use
Tram ART 1 or BP1
Slot 3 Series 7000 Waveform A (Right Side or Module)
Slot 4 Series 7000 Waveform A (Right Side or Module)
Signal GND for Series 7000 Waveforms
Tram ECG II
Tram ECG V
Tram BP4 or RESP
Reserved for Future Use
Tram BP2 or SPO Waveform
2
Slot 3 Series 7000 Waveform B (Left Side or Module)
Slot 4 Series 7000 Waveform B (Left Side or Module)
127(
1
The top displayed trace on the monitor is present unless AVR, AVL,
or AVF leads are used, then lead II is output.
1. Plug the Tram-rac housing cables into each of the three Tram-net
connectors (blue).
2. Verify that the waveforms recover on the monitor display each time
the cable is reconnected.
Solar 9500 Information Monitor
2001085-061
Tram-rac 4A
Bezel Number for BP
Output
–
1
Tram
1
Tram
–
Tram
Parameter 6
Parameter 8
–
1
Tram
1
Tram
1
Tram
–
Tram
Parameter 5
Parameter 7
Revision A