Display Descriptions; Primary Display; Secondary Display; Remote Display 1, 2 - GE Medical Systems Solar 9500 Service Manual

Display Descriptions

Primary Display

Secondary Display

Remote Display 1, 2

3-6
Installation: Display Descriptions
A single Solar 9500 processing unit can be connected to up to three
displays as shown in the block diagram below and described as follows:
This is the first in a series of monitors or may be the sole monitor
connected to the Solar 9500 processing unit. The primary display is
distinguished from the other monitors by the eight control buttons
displayed at the bottom of the screen. Real Time data (parameter
waveforms and numerics) and/or Non-Real Time data (a display with
trends, alarm history, etc.) are displayed on this screen.
A secondary display has touchscreen capabilities and displays Real Time
and/or Non-Real Time data on a two or three display system.
A remote display is a view only monitor and is not intended to be used as
a touchscreen display. No user interface or applications in display setup
are available. Up to two remote displays can be connected to the Solar
9500 processing unit.
Solar 9500 Information Monitor
2001085-061
011A
Revision A