Creating A Custom Layout; Editing Basics For All Customizable Windows - GE Medical Systems Solar 9500 Service Manual

Creating a Custom Layout

Editing Basics for All Customizable Windows

Revision A
Software Configuration: Creating a Custom Layout
The Solar 9500 Information Monitor allows you to create and configure
custom screen layouts to suit your needs.
With configuration editing enabled, any of the windows on the screen can
be resized from any corner. Windows can also be moved around on the
screen, by grabbing the edge of the window.
127(
Windows cannot be moved outside of the bed window in which they
were created.
If the layout you just configured is something you would like to reuse,
save the layout before disabling configuration editing. For more
information on saving a layout, refer to "Creating a Bed" in this
chapter.
When Configuration Editing is enabled, pressing a command button,
parameter window or waveform window, will cause a different option
menu to be displayed instead of the normal action.
The following are basic editing principles for working with customizable
windows.
:$51,1*6
Do not configure the screen in such a way that parameter
and alarm data is obscured. This could delay recognition
of critical events when monitoring a patient.
Always turn layout configuration OFF when finished
with configuration editing. Failure to turn configuration
off may result in accidental configuration changes by the
operator and loss of important data.
127(
Configuration editing must be enabled.
It may be easier to use a mouse for these operations. For all
operations use the left button only. The right button is not used.
Click and hold the cursor on the background of a window to display a
pop-up menu listing options for that window.
Select the edge of a window to show the
dragged to an appropriate spot on the display.
Select any corner of a window to show a right angled or "L" shaped
cursor and allow the window to be resized.
Solar 9500 Information Monitor
2001085-061
cursor and allow it to be
4-23