Installing Cable Shroud - GE Medical Systems Solar 9500 Service Manual

Installing Cable Shroud

Revision A
Installation: Processing Unit Setup
After installing all of the interface cables, use the following instructions
to install the cable shroud.
1. Remove the front cover as instructed in "Processing Unit Setup" on
page 3.
2. Snap the cable shroud, pn 420235-001, onto the side of the Solar
9500 housing.
3. Secure with the three self-tapping screws provided, pn 45177-205.
4. Replace the front cover as instructed in "Processing Unit Setup" on
page 3.
&$87,21
Do not force the cover. Ensure that the front cover is
aligned properly on its hinges before closing. Forcing the
front cover into place with improper alignment will cause
damage to the cover.
Solar 9500 Information Monitor
2001085-061
010A
3-5