Create A Standard Query - AB Sciex QTRAP 4500 LC/MS/MS system System User's Manual

Operating Instructions — Analyze and Process Quantitative Data
8. Click Next.
Note: To create a query at the same time, refer to
Query on page
The Create Quantitation Set - Select Method page opens.
9. Click Choose Existing Method.
10. In the Method list, select PK Data_Mix.qmf.
11. Click Finish.
The Results Table opens.
Tip!
Results Table > Add/Remove Samples.
12. Save the Results Table.
Tip!
Reporter software. It is recommended that the user validate the results if a
Reporter template that contains a query is used. Refer to the Reporter
chapter.

Create a Standard Query

A query and a standard query can be created numerous ways. The following is one example. For
more information about creating queries, refer to the Help.
It is recommended that the user validate any queries that are used to analyze data in a Results
Table.
1. In the navigation bar, under Quantitate, double-click Quantitation Wizard.
2. In the Create Quantitation Set - Select Samples page, select samples.
3. Click Next.
4. In the Select Settings & Query page, in the Default Query section, select Create
New Standard Query.
5. Type a query name.
4500 Series of Instruments
98 of 138
98.
To add or remove samples in the Results Table, click Tools >
You can create well-formatted reports from a Results Table using the
Create a Standard
System User Guide
RUO-IDV-05-0264-A