Add Devices To A Hardware Profile - AB Sciex QTRAP 4500 LC/MS/MS system System User's Manual

14. In the Create New Hardware Profile dialog, click OK.
15. In the Hardware Configuration Editor, click the hardware profile.
16. Click Activate Profile.
The check mark turns green. If a red x is shown, then there is an issue with the
hardware profile activation. For more information, refer to
Profile Activation.
Tip!
activated. Click a hardware profile and then click Activate Profile. The
other profile is deactivated automatically.
17. Click Close.

Add Devices to a Hardware Profile

Devices must be configured to enable the software to communicate with them.
When the software is installed, the driver required for each device is also installed. After the
devices are physically connected to the computer, configure the device.
1. Open the Hardware Configuration Editor.
2. In the Hardware Profiles list, deactivate the hardware profile.
3. Click Edit Profile.
4. Click Add Device.
5. In the Available Devices dialog, in the Device Type list, select the device.
6. Click OK.
Figure 6-6
7. In the Devices in current profile list, select the device.
8. Click Setup Device.
A dialog containing configuration values for the device opens.
9. (Optional) On the Communication tab, in the Alias field, type a name or other
identifier.
System User Guide
RUO-IDV-05-0264-A
A hardware profile does not have to be deactivated before another is
Available Devices Dialog
Operating Instructions — Hardware Profiles and Projects
Troubleshoot Hardware
4500 Series of Instruments
43 of 138