Table of Contents
Advertisement
4.3 PUNCHING
1.
Push On Button "R" to turn machine on.
2.
Loosen Punch Edge Guide Knob, and position Punch Edge Guide "A" so line on decal
matches paper size line on Punch Platen "H". Proper positioning of the Punch Edge Guide
"A" allows correct punching of your document to ensure it does not extend beyond the
strip on either end when bound.
3.
Select the desired punch mode.
A. To select "Automatic Punch Mode", press Auto Punch Button "N".
document into the Punch Throat squarely just to the right of the Punch Edge Guide "A"
and slide your document left to the Punch Edge Guide "A" to activate the punch cycle
(the metal piece you see inside the guide is the punch cycle "trigger" or "actuator").
B. To punch manually, insert your document into the Punch Throat squarely next to the
Punch Edge Guide "A", and press the Manual Punch Button "O".
C. To punch using the Foot Pedal, insert your document into the Punch Throat squarely
next to the Punch Edge Guide "A", and depress the Foot Pedal.
4.
Punch a test sheet of paper. Fold punched test sheet to check punch hole location and
alignment from edges of paper to ensure holes are equally spaced from edges of sheet (see
Figure 4-2). Adjust Punch Edge Guide "A" if necessary, and recheck test sheet punched
after adjustment.
5.
After ensuring your Punch Edge Guide "A" is properly positioned, tighten the Punch Edge
Guide Knob, jog document to be punched so all edges are even, and insert document into
Punch Throat according to step 3-A or 3-B instructions depending on punch mode selected.
4.0 OPERATING INSTRUCTIONS
Figure 4-2
4-5
Insert your
9781858-02/02
Advertisement
Table of Contents
