Table of Contents
Advertisement
4.5 BINDING
1.
Press >1" Button "K" or <1" Button "L" to place machine in desired binding mode.
2.
Lower the Pressure Bar "C" onto top binding strip and document stack.
3.
The binding cycle will begin immediately and automatically. When the binding process is
completed (approximately 16 seconds in >1" mode, and 8 seconds in <1" mode), the Pressure
Bar "C" will raise automatically, and the bound document can be removed.
4.
The Debris Tray "J" should be checked and emptied frequently if the machine is used
consistently. If periodically used, Debris Tray "J" should be checked and emptied on a daily
basis. Make sure the Debris Tray "J" is reinserted properly and completely into the Base.
Excess pin buildup and damage may occur if the tray is not inserted fully into the base.
4.0 OPERATING INSTRUCTIONS
Figure 4-4
4-7
9781858-02/02
Advertisement
Table of Contents
