Table of Contents
Advertisement
6.1 PUNCH BRAKE SWITCH (S8)/PUNCH CAM ADJUSTMENT - Figure 6-1
1.
Disconnect Power Cord from the wall outlet.
2.
Remove Housing from the machine.
3.
Tape the Bind Platen Interlock Safety Switch down, or place a heavy object on it to hold the
actuator down.
4.
Reconnect Power Cord to the wall outlet, and turn machine "On".
5.
Make sure Auto/Manual Punch Switch is in "Manual" Punch Mode. Depress "Manual
Punch Switch" to cycle machine once. Make sure Punch Actuator is in the peak up
position, and turn machine "Off".
6.
Loosen the Punch Brake Switch (S8) Screws, and raise Switch so the Right Mounting
Screw is fully raised in its channel.
7.
Adjust the left side of Switch until Actuator is parallel with the Switch body as shown in
Figure 6-1.
8.
Tighten both Switch Mounting Screws snugly.
9.
Loosen the Set Screw in the Punch Cam, and rotate the Cam until it actuates the Punch
Brake Switch (S8).
10.
Tighten Set Screw. Do not over tighten as it is easily cracked.
11.
Test Punch with a 1/8" (3.2 mm.) stack of paper in both Manual and Auto Punch Modes,
and readjust if necessary.
6.0 ADJUSTMENTS
Figure 6-1
6-1
9781858-02/02
Advertisement
Table of Contents
