Table of Contents
Advertisement
6.10
DISASSEMBLY INSTRUCTIONS (CONTINUED)
6.10.7
REPLACING THE KNIFE BLADE/HEATERS
1. Disconnect Power Cord from wall outlet.
2. Remove the Housing.
3. Loosen the 2 Cutting Depth Adjustment Screws.
4. Remove the 7 Retaining Nuts and Lock Washers from the Knife Bracket Studs.
5. Carefully left off the Knife Plate, and Upper Insulator.
6. Carefully lift the Upper Heater up and away from the Knife Blade.
7. Remove the Knife Blade, and check the 7 Ceramic Insulators to make sure they are
8. Replace the Knife Blade and/or Heaters, and reassemble in reverse order.
NOTE: MAKE SURE THE "HEAT SIDE" IS FACING THE KNIFE BLADE ON
BOTH THE TOP AND BOTTOM.
6.0 ADJUSTMENTS
not broken - replace any broken insulators.
6-16
9781858-02/02
Advertisement
Table of Contents
