General Binding SureBind 230VAC Service Manual page 10

4.4 DOCUMENT ASSEMBLY
1. Insert the bottom strip (strip with holes) into the Strip Recess "F", textured side down, fitting
the small hole in strip over the Locating Pin "D" which protrudes slightly from the bottom
surface of the Strip Recess "F". Note: The position of the Locating Pin is indicated by the
arrow painted on the Backstop "E". When the strip is correctly positioned, the hole closest to
the left end of the strip will be aligned with the vertical line on the Backstop "E".
Note: Failure to properly place the small hole in the bottom strip over the
Locating Pin will result in the pins not being cut off, and can jam up the
machine.
2. Place the punched document face up (first sheet on top and last sheet on bottom) on the Bind
Platen "G", with the left edge of the document next to the Bind Edge Guide "B", and the
punched edge resting against the Backstop "E". Note: The Bind Edge Guide "B" is properly
adjusted when the punched holes of the document are aligned with strip holes and the left
edge of the document is resting next to the Bind Edge Guide "B".
3. The maximum binding capacity of the machine is 3 inches. If document is to be enclosed in a
soft cover, the front and back covers must be assembled as shown in Figure 4-3, and bound
into the document at this time. If document is to be enclosed in a hard cover, VeloBind
endsheets must be bound into the document at this time. The endsheets are placed on the
front and back of the document with the printed release paper facing out, and the plain white
sides facing the first and last sheets of the document. (The hard cover will be attached to the
document after the binding is completed.)
4. Insert the top strip (strip with pins) into the holes in the document and bottom strip. Press the
top strip down firmly until it contacts the top sheet of the document.
4.0 OPERATING INSTRUCTIONS
4-6
9781858-02/02