General Binding SureBind 230VAC Service Manual page 61

6.10 DISASSEMBLY INSTRUCTIONS (CONTINUED)
6.10.5 REPLACING THE PUNCH PINS OR ACTUATOR
1. Disconnect Power Cord from rear of machine.
2. Remove the Housing.
3. Insert a piece of cardboard (a few vinyl covers will do) into the Punch throat to keep
the Punch Pins from dropping.
4. Loosen the Left and Right Socket screws attaching the Z Brackets to the Side Plates.
Move the Left and Right Punch Links off the Punch Actuator Tabs.
5. Remove the 3 Retaining Clips and Retaining Pins holding the Punc h Actuator to the
Punch Housing. The Punch Actuator, Spacer, and Pins can now be removed and
replaced as necessary. (NOTE: Be sure to check the Punch Actuator for broken
welds or warpage, and the Punch Die Holes for elongation.)
6. Reassemble in reverse order. (NOTE: New Retaining Clips must be inserted on the
Retaining Pins to properly assemble the Punch.*)
*NOTE: THERE MUST BE NO PLAY BETWEEN THE PUNCH ACTUATOR,
SPACER, AND PUNCH HOUSING. The Retaining Clips can be easily and securely
installed using a Punch Housing Tool - Part Number 9777705. This is basically a "C"
Clamp which has a drilled out hole for the Retaining Pin to protrude through as the
"C" Clamp tightens the Retaining Clip over it.
6.0 ADJUSTMENTS
6-14
9781858-02/02