General Binding SureBind 230VAC Service Manual page 48

6.2 BIND TIMING ADJUSTMENT - Figure 6-2
6.2.1 BIND TIMING SWITCH (S13) ADJUSTMENT
1. Disconnect Power Cord from the wall outlet.
2. Remove the Housing.
3. Remove Timing Belt from Bind Motor Pulley and Cam Shaft Pulley.
4. Manually rotate the Cam Shaft counterclockwise until the Drive Gear Teeth engage
the Drive Arm Teeth.
5. Continue rotating the Cam Shaft until the Drive Arm drops, and the teeth on the
Drive Gear are just past the teeth on the Drive Arm. (Note: Switch must be actuated
at this point).
6. Loosen the Bind Timing Switch Bracket Adjusting Screw, and adjust the Bracket
until it touches the Bearing, and tighten the Bracket Adjusting Screw.
7. Loosen the Bind Timing Switch (S13) Retaining Screws, and move Switch (S13) so
that Right Hand Retaining Screw is at the top of the Switch Mounting Bracket Slot.
Tighten the Right Retaining Screw.
8. Make sure Bind Timing Switch (S13) is actuated, and tighten the Left Retaining
Screw.
9. Replace the Timing Belt, and test the bind timing adjustment on both Standard and
Fast Bind Speeds. Minor readjustment may be necessary.
6.0 ADJUSTMENTS
Figure 6-2
6-2
9781858-02/02