Table of Contents
Advertisement
4.6 DEBINDING
1. Place document to be debound as follows:
A. Bound edge against Backstop "E".
B. Small hole in bottom strip over Locating Pin "D".
C. Edge of document next to Bind Edge Guide "B".
2. Once the document to be debound is properly located, press the Debind Button "M" to place
in debind mode.
3. Lower the Pressure Bar "C" onto document, and the machine will go through the debinding
cycle.
4. Immediately after the Pressure Bar "C" raises (approximately 25 seconds), remove the
document and peel the top strip off.
5. Press either Standard Bind Button "K", or Fast Bind Button "L" to place the machine back in
binding mode.
4.0 OPERATING INSTRUCTIONS
4-8
9781858-02/02
Advertisement
Table of Contents
