System board and components
"Installing the iRMC microSD card" on page 292
Ê
Ê Reconnect all cables to the system board. For a complete cabling overview,
see section
"Cabling overview" on page
"Installing OCP mezzanine cards" on page 159
Ê
"Installing the riser module" on page 55
Ê
I
Install the expansion cards into their original slots.
"Installing the FBU" on page 139
Ê
"Installing a memory module" on page 191
Ê
I
Install the memory modules into their original slots.
9.6.3
Concluding steps
Perform the following steps:
"Installing the server node in the server enclosure" on page 67
Ê
Ê If applicable, reconnect all external cables.
"Controls and indicators on the server node" on page 448
Ê
"Verifying system information backup / restore" on page 83
Ê
"Using the Chassis ID Prom Tool" on page 99
Ê
This action is not required if the system information restore is successfully
done.
"Updating or recovering the system board BIOS and iRMC" on page 77
Ê
applicable)
"Verifying the system time settings" on page 92
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, see section
page
97.
318
(if applicable)
"Looking up changed MAC/WWN addresses" on
Upgrade and Maintenance Manual
(if applicable)
420.
(if applicable)
(if
CX2550/60/70 M4