SXM2 extension tray
1. Loosen the four captive screws one by one (in the sequence 4 to 1)
rotating them a half-turn each.
2. Loosen the captive screws 4 and 3 rotating them two or three turns each.
3. Repeat the step 2 until the screws 4 and 3 are completely loosened.
4. Loosen the captive screws 2 and 1 rotating them two or three turns each.
5. Repeat the step 2 until the screws 2 and 1 are completely loosened.
Ê Repeat the procedure for SXM2 module 2 (B).
Ê Remove the LC heat sinks.
372
Upgrade and Maintenance Manual
CX2550/60/70 M4