Installing An Expansion Card; Connecting Cables To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY CX2560 M4 Upgrade And Maintenance Manual

Expansion cards and OCP mezzanine cards
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board, see section
page 165.
6.3.3.3

Installing an expansion card

Ê If applicable, install a slot bracket on the new expansion card, see section
"Mounting expansion card slot brackets" on page
Ê Install the new expansion card, see section
SXM2 riser card (L) type 2" on page
Ê If applicable, install a TFM on the expansion card, see section
TFM" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, see section
6.3.3.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, see section
6.3.3.5

Concluding steps

Perform the following procedures:
"Installing the SXM2 riser (L) type 2" on page 412
Ê
"Installing the GPGPU / SXM2 extension tray" on page 65
Ê
"Installing the server node in the server enclosure" on page 67
Ê
Ê Reconnect all external cables.
"Enabling replaced components in the BIOS" on page 89
Ê
"Enabling SVOM boot watchdog functionality" on page 88
Ê
"Updating expansion card firmware" on page 83
Ê
"After replacing/upgrading LAN controllers" on page 100
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 94
"Looking up changed MAC/WWN addresses" on page 97
Ê
136
"Mounting expansion card slot brackets" on
140.
"Installing SFP+ transceiver modules" on page
Upgrade and Maintenance Manual
165.
"Mounting an expansion card to
129.
"Cabling" on page
(if applicable)
"Installing a
172.
421.
(if applicable)
CX2550/60/70 M4