Cables
12.3.2.3 Disconnecting the cables from the Omni-Path PHY card
Ê Remove the riser module, see section
page
58.
Ê Remove the controller from the riser module, see section
controller from the riser module" on page
Figure 330: Disconnecting the cables from the Omni-Path PHY card
Ê Disconnect the plugs of the Omni-Path PHY card signal cable from the
Omni-Path PHY card by unlocking the latches of the Omni-Path PHY card
signal cable (1).
Ê Disconnect the Omni-Path PHY card sideband cable from the Omni-Path
PHY card (2).
Ê Install the riser module, see section
434
"Installing the riser module" on page
Upgrade and Maintenance Manual
"Removing the riser module" on
123.
"Removing a
55.
CX2550/60/70 M4