Mounting A Controller To The Riser Module - Fujitsu PRIMERGY CX2560 M4 Upgrade And Maintenance Manual

Expansion cards and OCP mezzanine cards
6.2.1.2

Mounting a controller to the riser module

Figure 32: Mounting a controller to the riser module
"Removing the slot cover from the riser module" on page 61
Ê
Ê If applicable, install a TFM on the expansion card, see section
TFM" on page
If applicable, install a Flash Backup Unit (FBU), see section
Ê
FBU" on page
Ê Plug the controller on the riser card connector (1).
Ê Fasten the controller with one screw (2).
V
CAUTION!
Please assemble the expansion card so that the edge of the bracket
of the expansion card is lower than the edge of the riser metal
bracket.
120
140.
139.
Upgrade and Maintenance Manual
2
(if applicable)
"Installing a
"Installing the
CX2550/60/70 M4