DEC VAXstation 3100 Owner's Manual page 89

Figure 5-7 shows the correct way to remove a T-connector from an
active ThinWire segment.
Figure 5-7 Removing a System from an Active TtiinWire
Segment
Mi.O-002236
3 Make sure that no more than two Thin^re segments are
connected to the T-connector. If youremove a liiinWire cable,
replace it with a terminator.
4 Check that you have not disconnected a terminator from either
end of an active ThinWire segment. This procedure disrupts
network operation.
5 Check that all connections on the ThinWire Ethernet segment
a r e secure.
6 Check that there are no branches off a Thin\^re segment
except through a DEMPR (Digital Ethernet Multiport
Repeater). A DEMPR provides eight ThinWire Ethernet
drops from a single standard Ethernet connection. See the
Workstations Network Guide for additional information.
7 Check that a Thin'^re segment is not looped from one port on
the DEMPR to another port on the DEMPR.
Connecting to a Network 5-^