Removing A Compact Disc - DEC VAXstation 3100 Owner's Manual

Note Ifyou have the disc positioned label side up but the notches are
on the right, then the disc is oriented improperly in the caddy. ^
Proceed no further with the disc loading. See Section 3.2.4 and ' ^
Section 3.2.3.
3 Slide the caddy in as far as it will go and then remove the
transparent sleeve. The disc and its housing remain in
the drive. Only the transparent sleeve comes out. See
Figure 3-2.
4 Also note that the green light on the front of the disk drive
comes on and stays on.
The green activity light should come on within 5 seconds. If
the drive accepted the disc and caddy but the activity Hght
does not come on, the disc may be sitting incorrectly in the
caddy. Remove the disc and check to make sure that the label
is facing up as you insert the disc into the drive again.
3.2.2 Removing a Compact Disc
Before removing a compact disc, make sure that the green activity
light is not flashing. If the light is flashing, the compact disc
drive is transferring data. Wait until the green activily light stops
flashing. To imload a disc:
1 Position the transparent sleeve as for loading. Make sure the
arrow on the sleeve is pointing into the drive opening.
2 Insert the sleeve into the drive opening as far as it will go.
3 Remove the caddy. The disc and housing should be in the
sleeve. The green activity Hght should go out.
3-4 Learning About Your System