Strain Relief Strap - DEC VAXstation 3100 Owner's Manual

Top
USRS
Bottom
• Attach the universal strain relief strap to the color monitor
cable by following these steps:
• Insert the three BNC connectors and cable junction
block of the monitor cable through the center slot of the
universal strain relief strap, making sure the strap is
under the cable junction block.
Note The bottom side of the cable junction block has the smaller
of the two screw holes, and is dimpled. The universal
strain relief strap should lie against this side of the cable
junction block.
• Pull the monitor cable into the slotted hole at the bottom
end of the universal strain reUef strap and bring the strap
flush with the cable junction box.
• Align the center BNC connector (green) with the two key
slots of the closed hole at the top end of the universal
strain relief strap, and snap the BNC connector into the
hole.
• Follow the instructions in your monitor guide to attach the
BNC connectors to the back of the monitor.
Figure 2-9 shows the monitor cable attached to the back
of a monitor using the universal strain relief strap.
Figure 2-9 Connecting the Monitor Cable to ttie Monitor
Using ttie Universal Strain Relief Strap
BNC Connectors
USRS
Cable Junction Block
MLO-004S80
2-12 Installing System Hardware