Inserting Disc In Housing - DEC VAXstation 3100 Owner's Manual

Notches
Label
lb place a compact disc into a caddy, perform the following steps:
1 Hold the disc with yoiir free hand. Position the housing and
disc as shown in Figure 3-4 (always work with the disc so the
label is facing up, and the four notches on the housing are to
the left).
2 Position your thumb on the outer edge of the disc and your
index finger in the center hole of the disc.
3 Slip the disc into the housing. The inside of the housing is
grooved to accept the disc. Exert inward pressure on the
housing to hold the disc in the housing.
Figure 3-^ Inserting Disc in Housing
MLO-002351
Slide the housing into the transparent sleeve imtil it clicks
into place.
Turn the assembled caddy so that the label on the disc is
&cing up. Make sure that the notches on the housing are
on the left. If the notches are not on the left when the disc
is label side up, then the disc is mounted inside the caddy
incorrectly. Remove the disc fi:x)m the caddy, turn the disc
over, and place it in the caddy in the correct position.
3-6 Learning About Your System