Unpacking An Expansion Box - DEC VAXstation 3100 Owner's Manual

4.2 Unpacking an Expansion Box
Note This section describes the TK50Z-GA expansion box, the RZ55
expansion box and the KRD40 compact disc drive. The newer
RZ5x-xx eoqjansion box options have their own user documentation.
Please refer to individual RX5x-xx documentation for specific
installation instructions.
Each expansion box is shipped from the factoxy with the following
accessories, as shown in Kgure 4—2:
• Either a cable with a 68-pin connector at one end and a 50-pin
connector at the other end, or a cable with a 50-pin connector
on each end and a 68-pin to 50-pin adapter, which you will
plug into one end of your 50-pin cable. Use this cable (and
the adapter, if necessary) to connect the expansion box to the
system unit.
Nofe The 68-pin connector is shaped differently from the 50-pin
connector. See Figure 4-2.
One 50-pin to 50-pin cable. Use this cable to connect two
expansion boxes in a chain.
One power cord.
One bottom dress cover (for RZ55 or TK50Z-GA). See
Section 4.3.
One 50-pin terminator, as shown in Figure 4—1. Use this to
terminate the last expansion box.
Figure 4^1 50-Pin Terminator
MLa«02346
4-4 Adding and Using Expansion Boxes