Rebooting The System After Running Tests - DEC VAXstation 3100 Owner's Manual

Table of Contents

Advertisement

7
You must now log in at the console prompt to use SHOW or
other privileged commands. At the console prompt (>») type
—,
in LOGIN and press the Return key.
^ ^
8
The console will respond with the prompt (? »>). Type in
your 16 character password and press the Return key.
9
If the password you type in is not correct, the console responds
vsdth the following code:
723
ILL CMD
10 If the password was accepted, you may now proceed to use
privileged commands or you may disable the password feature
by t3T)ing the command SET PSE 0 at the console prompt
(»>) and pressing the Return key. As you perform any of the
commands in the privileged state (except for SET PSE 0) and
leave the console mode, the insole will be left in a secure
state. Use of the password will once again be required to
perform privileged commands once you return to the console
mode.
7.12 Rebooting the System After Running Tests
While you are running any of the tests or procedures in this
chapter, you are in console mode. To resume normal operation of
the Model 48, you must reenter program mode. There are two
ways to enter program mode:
1
Enter BOOT at the console prompt and press the Return
key. The system then searches each device in turn for the
operating system software.
2
Enter BOOT followed by a space and the name of the device
that contains your software, as shown in the following
example:
BOOT DKA300
[Retoml
This procedure lets the system boot the software immediately,
without searching.
See Appendix A for information on setting your system
parameters.
7-28 Running Diagnostics

Advertisement

Table of Contents
loading

This manual is also suitable for:

Model 48

Table of Contents