Agilent 2200 Tapestation Set Up - Agilent Technologies 2200 TapeStation User Manual

Agilent 2200 TapeStation Set Up

Hardware required Laptop
Software required Agilent 2200 ScreenPlex Software (already installed)
TestKitSuite.xml file from Test Kit Manufacturer
Personal injury, explosion or fire
WA R N I N G
➔
➔
➔
For general safety information, please refer to the 2200 TapeStation System - Site and
N O T E
Safety Manual.
Use of unsupplied cables or power adaptors
WA R N I N G
Using cables or power adaptors not supplied by Agilent Technologies can lead to
damage of the electronic components or personal injury.
➔
1 Connect the supplied USB cable between the port on the back of the
2 Power the instrument with the supplied power lead and adaptor.
3 Turn the instrument on using the power switch located at the back of the
2200 TapeStation
Do not operate the instrument in an atmosphere containing explosive gases or near
flammable volatile liquids.
Only approved mains cord set supplied with the instrument must be used with this
instrument and if an extension lead is required, the lead must be earthed.
If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Never use cables or power adaptors other than the ones supplied by Agilent
Technologies to ensure proper functionality and compliance with safety or EMC
regulations.
instrument and your laptop.
TapeStation.
When powered and idle, the instrument will have a blue LED visible on the
front of the case.
Installing the System
Installing the System
3
21