Set up the Detector with Agilent Open Lab ChemStation
The setup of the detector is shown with the Agilent OpenLab ChemStation
C.01.06.
This section describes the detector settings only. For information on the Agilent OpenLab
N O T E
ChemStation or other 1200 Infinity modules refer to the corresponding documentation.
Figure 7
After successful load of the OpenLab ChemStation, you should see the
module as an active item in the graphical user interface (GUI).
Agilent 1290 Infinity II VWD User Manual
Set up the Detector with Agilent Open Lab ChemStation
ChemStation Method and Run Control (just detector is shown)
3
Using the Module
37