Set Up The Detector With Agilent Open Lab Chemstation - Agilent Technologies InfinityLab LC Series User Manual

3 Using the Module

Set up the Detector with Agilent Open Lab ChemStation

Set up the Detector with Agilent Open Lab
ChemStation
The setup of the detector is shown with the Agilent OpenLab ChemStation
C.01.07 and LC and CE Drivers A.02.13.
This section describes the detector settings only. For information on the Agilent
NOTE
OpenLab ChemStation or other 1200 Infinity modules refer to the corresponding
documentation.
Figure 13
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
Agilent InfinityLab LC Series RID User Manual
ChemStation Method and Run Control (just detector is shown)
49