Adding Effects
Functions of Effect Parameters
Part Output
Here you can make output settings for the Performance.
* These parameters are the same as the corresponding
Performance settings. For details, refer to Output Level (Part
Output Level) (p. 137).
1
Part Output Level
Set the level of the signal that is sent to the output
destination specified by Part Output Assign (
Value:
0–127
2
Part Chorus Send Level
Sets the level of the signal sent to chorus for each part.
Value:
0–127
3
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value:
0–127
4
Part Output Assign
Specifies for each part how the direct sound will be output.
Value
MFX:
Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R:
Output in stereo without passing through multi-
effects.
L, R:
Output in mono without passing through multi-
effects.
PAT:
The part's output destination is determined by
the settings of the patch or rhythm set assigned
to the part.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through
the chorus is set with the Chorus Output Select (
146
5
Part Output MFX Select
(Part Output Multi-Effects Select)
Of the three systems of multi-effects that can be used
simultaneously, specify which multi-effects will be used.
Value:
MFX1–3
For the following parameters
made individually for three systems multi-effects (MFX1–
MFX3).
6
MFX Type (Multi-Effects Type)
4
).
Use this parameter to select from among the 78 available
multi-effects.
Value:
12
).
1–3(MFX-1–MFX-3)
6
9
–
0 (Through)–78
, settings can be